How to replace side door cable on Sienna?

How to replace side door cable on Sienna?

Without further ado, here’s how you can replace the side door cable assembly in your Sienna: Take out the seat closest to the defective sliding door. (Optional; this just gives you more room to work on the door.) Roll down the window on the defective door. On the side of the door is a hex screw holding the plastic panel in place. Remove the screw.

Can you change the turn signal bulb on a Jeep Wrangler?

When changing the turn signal bulb in your Wrangler, be careful not to touch the glass portion of the bulb with your fingers as this will cause the bulb to burn out prematurely.

Where is the release actuator on a Sienna?

There’s a pulley system with a Sienna side door release actuator in the bottom corner of the door. (If you’re working on the right door, the pulley system is in the bottom right corner; on the left door, the pulley system is on the bottom left corner.) Remove all of the screws holding it in place. Slide-out the side door cable assembly.

Without further ado, here’s how you can replace the side door cable assembly in your Sienna: Take out the seat closest to the defective sliding door. (Optional; this just gives you more room to work on the door.) Roll down the window on the defective door. On the side of the door is a hex screw holding the plastic panel in place. Remove the screw.

Are there any problems with the Toyota Sienna?

Many Sienna owners successfully resolve this issue by replacing it with an OEM metal cooler pipe (Part No. 15767-31020 ). Shift Lock Solenoid Failure: The shift lock solenoid in 2004-2009 Siennas is prone to failure, which allows the driver to move the shift lever out of the park position without depressing the brake pedal.

What does the courtesy switch on a Toyota Sienna do?

Courtesy Switch — Detects whether the back door is open or closed. This switch turns on when the back door is open or ajar and turns off when the back door is closed. To understand what these switches do, here is the closing sequence logic.

Why is the sliding door on my Toyota Sienna not working?

Sliding Door Latch Failure: The sliding door in in this generation of Sienna minivans comes with a latch that doesn’t always do its job. This causes the door to not open when commanded and triggers the door to open at unexpected times, including while the van is in motion.

When did power sliding door on Toyota Sienna Le stop working?

In 2014, the driver’s side power sliding door cable snapped on our 2009 Toyota Sienna LE with about 150,000km. It stopped working and you could see a rusted cable hanging outside of the third row window.

How to install rear side window on Toyota Sienna?

INSTALL POWER VENT WINDOW MOTOR ASSEMBLY LH 4. INSTALL SIDE WINDOW ASSEMBLY REAR LH 5. INSTALL RR WINDOW DESCRIPTION This monitor will run when the engine is started at -10 to 50°C (14 to 122°F) of the engine coolant temperature. The DTC will set after the engine idling for 13 seconds (2 trip detection logic).

There’s a pulley system with a Sienna side door release actuator in the bottom corner of the door. (If you’re working on the right door, the pulley system is in the bottom right corner; on the left door, the pulley system is on the bottom left corner.) Remove all of the screws holding it in place. Slide-out the side door cable assembly.

How do you replace a sliding door cable?

Remove the nut holding the cable in the bracket and then slide the cable assembly out of the bracket. Inside the door, there are three bolts holding the cable assembly in place (where the cable makes a right angle turn). Remove all three bolts. Under the arm that connects the door to the van body are two more bolts. Remove them both.

Are there any issues with the Toyota Sienna sliding doors?

To avoid this, cancel and sign in to YouTube on your computer. An error occurred while retrieving sharing information. Please try again later. Toyota has received reports of customer concerns regarding rear sliding doors that gradually become difficult to open or close in certain 2004-2010 model year Sienna vehicles.

What kind of warranty does Toyota Sienna have?

1) Rear Sliding Door Latch Assemblies – For certain 2004-2010MY Sienna vehicles equipped with a Manual or Power Sliding Door, the warranty coverage for the Rear Sliding Door Latch Assemblies will be extended to 9 years from the date-of-first-use or 120,000 miles (whichever occurs first).