What are the OBD codes on a GM vacuum sensor?

What are the OBD codes on a GM vacuum sensor?

GM OBD1 Codes 13 O2 sensor or circuit 56 vacuum sensor Quad drvier B (3.8L) 58 Trans code-TTS temp high 59 Trans code-TTS temp low 61 O2 sensor signal faulty

What kind of problem does a 93-95 Chevy Van have?

Wiring open circuit/short circuit to ground, supply wire, transmission internal wiring, TCC solenoid, transmission mechanical fault, ECM

Where is the DLC on a GM 94?

Locate Data Link Connector (DLC), see image below. Turn Ignition switch to ON position. Count the flashes on the “ CHECK ENGINE ” or “ SERVICE ENGINE ” light. NOTE: Some 94 & 95 models do not have the B terminal. In which case a scanner is required.

Do you need a scanner for a GM 94?

NOTE: Some 94 & 95 models do not have the B terminal. In which case a scanner is required. NOTE: Some 94 & 95 models that DO have the A & B terminals still require a scanner. All vehicles after 96 are OBDII,and require a scanner to access them.

What happens to the crank sensor on a GMC?

The crankshaft sensor on GMC vehicles is synced to the powertrain control module, or PCM. When the crank sensor is replaced, it must be resynced to the PCM. Without resyncing, the PCM cannot properly determine the position of the crankshaft.

Can a bad sensor cause a check engine light?

Depending on your vehicle model, your engine might experience one or more of these performance problems: However, these symptoms are not exclusively symptoms of a failed MAP sensor. Sometimes, a bad sensor may trigger the check engine light (CEL).

Can a bad MAP sensor cause engine failure?

MAP sensor on footwell inside engine compartment. A bad manifold absolute pressure (MAP) sensor can upset fuel delivery and ignition timing. Depending on your vehicle model, your engine might experience one or more of these performance problems: However, these symptoms are not exclusively symptoms of a failed MAP sensor.