What does infinite reading on Ignition Meter mean?
Switch your meter to the Ohms setting and test the wiring again. An infinite reading on your meter means that there is no continuity and your wiring is faulty. Make sure to check all wiring going to and from the ignition module and spark plugs since wires are much easier and cheaper to replace than engine parts.
How to test an ezygo golf cart ignition switch?
How to Test a EZYGO Golf Cart Ignition Switch 1 There are two probe wires present in the battery pack – a black and a red. 2 Connect the black probe wire to the 36v negative terminal of the battery pack. 3 The red probe wire should be connected to the back of the battery pack. 4 With the key in the off position, check the wires.
How to test and replace a golf cart ignition switch?
Turn the ignition key to ON position and now, the first wire should have some voltage passing through it as well. This test will prove whether the ignition switch has some issue or not. If you have identified an issue with the ignition switch on your EZYGO, you may need to replace it with a new one.
How can I tell if my wiring is faulty?
You can also use your DVOM to check for continuity if there are no obvious visual signs of damage. Switch your meter to the Ohms setting and test the wiring again. An infinite reading on your meter means that there is no continuity and your wiring is faulty.
Can a multimeter be used to test an ignition switch?
It is, therefore, advisable to use a multimeter to test whether your ignition switch is working because it will check for both AC and DC voltage, current and resistance. Outlined below are several methods you can use to test the functionality of your ignition switch using both a digital and an analog multitester.
Switch your meter to the Ohms setting and test the wiring again. An infinite reading on your meter means that there is no continuity and your wiring is faulty. Make sure to check all wiring going to and from the ignition module and spark plugs since wires are much easier and cheaper to replace than engine parts.
What should the voltage be on an ignition switch?
Place the ignition switch to the run position after turning it on. The voltage of the battery should be reading at the positive terminal if the ignition switch is working effectively. If there is no voltage reading, or the reading is too low, there is a problem with the ignition wiring or the ignition switch.
How can I test the ignition switch on my car?
Outlined below are several methods you can use to test the functionality of your ignition switch using both a digital and an analog multitester. Under your steering wheel, locate your fuse panel and open it. Using your fuse pullers situated on the panel, pull the starter signal’s fuse.