What happens if your CV boot is torn?

What happens if your CV boot is torn?

It is possible to drive a car with a torn CV boot, but doing so will likely lead to further damage that will eventually require more extensive repair. Among the indications that a CV joint or axle has been damaged is a clicking or popping noise when turning, or vibrations at highway speeds.

Can a bad CV axle cause clunking?

You may have a worn out or damaged CV axle shaft which is commonly known to produce a clunking or clicking and popping sound when they fail.

Can I still drive with a damaged CV joint?

If the boot that seals the CV joint is damaged, the grease will leak out and contamination will set in, eventually causing the joint to wear out and fail. A severely worn out CV joint can even crumble while you’re driving and make the car undrivable. It is not safe to drive with a damaged CV joint.

What happens when a CV axle boot goes out?

This flexible joint is covered in a rubber boot that is referred to as the CV Boot. This boot serves as a simple dust cover for the CV joint meant to keep out dust and dirt, and keep in the grease that lubricates the CV joint. When a CV axle boot goes out, it opens up the potential for the CV joint to become damaged by contamination.

What are the symptoms of a torn CV boot?

3. Clicking noise during turns. Another more serious symptom of a potentially torn CV boot are clicking noises from the axle during turns. This is a symptom that the CV joint has become loose to the point where play has developed, causing it to click during turns.

What causes a CV axle to click when turning?

When CV axles become excessively worn, the joints will become loose and click when turning. The clicks may become louder or more pronounced during sharper and faster turns, and will be heard on the side with the faulty CV shaft.

Can a torn CV joint cause a car to turn?

Often times the grease can also be flung onto the chassis or other parts on the underside of the vehicle as the CV axle turns. A torn boot can also allow dirt, debris, and moisture to enter the CV joint, which will damage the joint.