What is CEC module?

What is CEC module?

CEC is a communications protocol built into the HDMI standard allowing CEC-enabled HDMI devices to exchange information and send/receive control messages. This allows a user to control more than one device using a single interface.

How do I prime my DT466E?

LPSMECH

  1. Disconnect the injector harness at the valve cover.
  2. Pump the hand primer to fill the fuel system until hard to depress.
  3. Crank the engine for 15 seconds.
  4. Repeat step 2.
  5. Repeat step 3.
  6. Repeat step 2.
  7. Repeat step 3.
  8. Repeat step 2.

How does CEC work?

CEC (Consumer Electronics Control) allows for HDMI devices to be controlled with one remote control. If you try to cast to a CEC supported TV while on a different source input (local TV channel, Cable, USB), source input will automatically switch to the HDMI port where the Chromecast is connected.

How much oil does a dt466e hold?

Fill engine with 28 quarts of engine oil with oil fill funnel and reinstall oil fill cap.

Why does my international 4300 DT466 not start?

If theres any air in it at all, it wont start. . The daytime running lights (DRL) and low beam headlights are inoperable. The highbeam headlights, markers and all other lights function properly. I have checked the fusebox in the engine compartment and above the glovebox and am unable to locate either a DRL/headlight, fuse or relay.

Can a 2007 IH 4300 run in sub zero temps?

The place I work at has a 2007 IH 4300 with a DT466. The past few days have been sub zero temps here. It ran fine the beginning of the week but yesterday it wouldn’t start. We pushed it in the garage and let in warm up over night. We also put the batteries on charge since they were pretty weak.

What are the engine codes for an international 4300?

Scanner says 8 engine codes. They are: FMI=4 VOLTAGE BELOW NORMAL OR SHORTED TO LOW SOURCE. FMI=3 VOLTAGE ABOVE NORMAL OR SHORTED TO HIGH SOURCE. SPN175 ENGINE OIL TEMP. SPN 102 BOOST PRESSURE.

Where are the lights on my international 4300?

The highbeam headlights, markers and all other lights function properly. I have checked the fusebox in the engine compartment and above the glovebox and am unable to locate either a DRL/headlight, fuse or relay. We would love to have a troubleshooting guide, or schematic, but have been unable to locate one on the internet.