What is the default username and password of Ubnt?

What is the default username and password of Ubnt?

The default username is ubnt and the default password is ubnt.

How do I reset my access point?

Unplug the access point’s power cable and wait for 30 seconds then plug it back in. Wait for the access point’s lights to appear solid. NOTE: Make sure to press and hold the Reset button properly. The lights on the access point should be blinking while you are holding the Reset button.

What is the default IP address of Cisco wap321?

If the wireless access points do not receive a DHCP response (there is no DHCP server on your network) after 60 seconds, the access points will fallback to the following default static IP address: 192.168. 1.245 and a default mask of 255.255. 255.0.

What is the default enable password for Cisco?

The default enable password is Cisco. The static information configured with the CLI commands is used by the AP to join a controller. After joining the controller, the user can configure new settings on the LAP via the controller.

Can a Cisco Aironet be converted to LWAPP?

These are the models that you can convert to Lightweight AP Protocol (LWAPP) mode: All Cisco Aironet 1130 AG APs All Aironet 1240 AG APs For all Cisco IOS Software-based Aironet 1200 Series modular AP (1200/1220 Cisco IOS Software upgrade, 1210, and 1230 AP) platforms, the ability to convert the AP depends on the radio.

Can a LWAPP converted AP communicate with a WLC?

LWAPP-converted APs communicate only with Cisco Wireless LAN (WLAN) Controllers (WLCs) and cannot communicate with WDS devices. However, the WLC provides functionality that is equivalent to the WDS when the AP associates to the WLC.

Can a CAPWAP controller be used with a LWAPP access point?

LWAPP-enabled access points can discover and join a CAPWAP controller, and conversion to a CAPWAP controller is seamless. For example, the controller discovery process and the firmware downloading process when you use CAPWAP are the same as when you use LWAPP. The one exception is for Layer 2 deployments, which are not supported by CAPWAP.