What should I do if my VT365 has no power?

What should I do if my VT365 has no power?

Wrench. Diagnostic Tech. If so, just monitor the can lines to see if they are talking to each other and check all sensor grounds. if all that is ok, then check circuit IDM relay vbat, that needs to be checked out. I think my bad english thinks this is what you mean by clean power.

What to do if your VT365 injector fails?

Another one of the ’05 IC’s with the VT365. I tried replacing the 40 amp fuse in the battery cable only to find that wasn’t blown. So they sent a mechanic out to do what he could on-site, and after about an hour he finally called for a tow truck. The engine would turn but wouldn’t catch, and the yellow engine light was on.

How did the VT365 cooling system get plumbed?

If you want customer service, you NEED an International! The VT 365 was “packaged” up so as to fit in tight applications such as Ford vans, so all that “stuff” got placed in the engine “V” which led to the VT365s cooling system being plumbed in series.

How much oil does a VT365 retain after an oil change?

The VT365 retains nearly one gallon of oil in its system that never drains out during an oil change, the percentage of retained versus drained oil is much higher than in a DT. In the 15 quart refill Ford applications over 25% of the oil circulating after an oil change is used oil that never drained out.

How did the VT 365 cooling system fail?

The VT 365 was “packaged” up so as to fit in tight applications such as Ford vans, so all that “stuff” got placed in the engine “V” which led to the VT365s cooling system being plumbed in series. This type of plumbing can lead to those domino type of failures where a problem in one component takes out a component down the line.

How many VT365 IC CE’s are in the fleet?

We have 16 2005 IC CE’s in our fleet all with the VT365. Within the last week, three of them have gone down with bad injectors. What could be the cause of so many injector failures all at once?