When does something go wrong with GM EGR valve?

When does something go wrong with GM EGR valve?

Vehicle runs great, just the annoying check engine light is on with one of the above diagnostic trouble codes stored in the PCM’s memory. When something goes wrong with the EGR system, you usually see one of the following: Chunks of carbon blocking the EGR valve’s pintle from fully seating in its seat.

What is the other side of the EGR vacuum solenoid?

The other side of the EGR vacuum solenoid has 2 ports. One is a vent port (that vents vacuum to the atmosphere) when the engine is idling. The other port connects to the EGR valve and should only have vacuum when the PCM commands the solenoid to activate.

Where are the EGR Jets in the intake manifold?

A more radical design, implemented in a few models, was the replacement of the valve with EGR jets at the bottom of the intake manifold. Some newer high-efficiency engines, for example those with variable valve timing (VVT), don’t even use an EGR system. If playback doesn’t begin shortly, try restarting your device.

Why does my Yukon not start on the first try?

About a week ago my Yukon started to have a starting issue. It will not always start on the first try but always starts on the second. There are a few things that I found while trying to diagnose this problem. It dosen’t matter if the engine is hot or cold and it only happens about 50% of the time.

Why is my EGR valve not working properly?

Chucks of carbon may also prevent the EGR valves from sitting as they should. The issue causes a rough idle, and in severe cases, the automobile might stall. This is because the exhaust gas does not re-circulate to the engine at idle, and it only happens when the motor exceeds the 30mph.

A more radical design, implemented in a few models, was the replacement of the valve with EGR jets at the bottom of the intake manifold. Some newer high-efficiency engines, for example those with variable valve timing (VVT), don’t even use an EGR system. If playback doesn’t begin shortly, try restarting your device.

Where is the EGR valve on a carburetor?

The tube connects the upper part of the EGR to the carburetor. The valveā€™s metal disk contains a vacuum diaphragm, a plunger, and spring. Most have an electronic-vacuum EGR valve that is placed inside a cylinder or a small block.