Where is the drain plug on a Honda Accord?
With the car in the air, you will want to position the drain pan below the location of the drain plug. The drain plug will be lower than the fill plug and will fit a 3/8″ square ratchet. Turn it clockwise to loosen.
How do you flush transmission fluid on a Honda Accord?
To completely flush the transmission fluid, perform Step 2 through Step 4 three times. Figure 2. Transmission drain plug on 2000 Honda Accord. Figure 3. Drain plug removed. Replace drain plug. Open the hood and remove the transmission fluid dipstick. The handle will be yellow and located near the battery.
What is transmission fluid on a Honda Civic?
Like many other components on your vehicle, the transmission fluid is a wear item that requires regular service. This article applies to the Honda Accord, and Civic (1992-2000). Transmission fluid is what allows the user to shift between gears smoothly.
What kind of fluid do I need for my Honda Accord?
Honda Accord automatic transmission fluid (ATF) change. (Non-CVTs) Fortunately, you do not need many tools to complete this job. This vehicle happens to be a 2003 model year, however, the job is very similar across many Honda vehicles. Regarding fluid type: Honda is specific with it’s ATF. Required is Honda – Acura ATF-ZI, DW-1.
How do you change the transmission in a Honda?
Start engine and shift into drive. Gently accelerate, but don’t go over 50mph. The idea is for the engine to shift through all the gears. Slow the car to a stop. Shift into reverse and drive up to 20mph before coming to a stop again.
How to replace a Honda Accord ATF drain plug?
Open drain plug with a 3/8″ socket drive When mostly drained, fluid flow will decrease to a dribble. Wait until fluid has drained to unscrew the drain plug all the way and remove it. Step 5 Clean plug and refill. Wipe metal filings and any fluid off the drain plug. Replace the drain plug and tighten to hand-tight.
Where is the oil filter on a Honda Accord?
The oil filter on a Honda Accord is located just aft and above the oil pan as shown in the following picture (orange). Use a 17mm wrench or socket ( nice socket set) to remove the drain plug. Have a drain pan ready as you loosen the drain plug.
How to replace transmission fluid in Honda Accord?
Tighten the drain plug using a Torque Wrench to 36 ft-lb of torque. Refill with a funnel and 3 quarts of the same fluid as before. Replace fill plug (or dipstick). Wait 15 minutes. Check transmission fluid level. Top off transmission fluid if needed. One day after the flush, inspect the transmission for signs of fluid leaking.
How often do you replace the transmission plug in a Honda Accord?
Fill transmission from fill plug (or dipstick). Use 2.5 quarts of Honda DW-1 Automatic Transmission Fluid. Use a funnel and pour carefully to not spill fluid. Replace fill plug (or dipstick). Wait 15 minutes, then check transmission fluid level. This allows fluid to enter all the corners of the transmission. If needed, add last 0.5 quarts of fluid.
Where is the dipstick for Honda transmission fluid?
Open the hood and remove the transmission fluid dipstick. The handle will be yellow and located near the battery. Insert funnel and fill the transmission with three quarts of Honda ATF. Figure 4. Location of transmission fluid dipstick. Figure 5. Refilling transmission fluid dipstick.
Which is Honda genuine OEM automatic transmission drain plug?
Details 20-Pack Transmission Fluid Drain Plug Crush Washer compatible with Honda Replacement for Part #90471-PX4-000 works with Accord Acura Civic Ridgeline Odyssey CRV CR-V Pilot Fit Element What other items do customers buy after viewing this item?
With the car in the air, you will want to position the drain pan below the location of the drain plug. The drain plug will be lower than the fill plug and will fit a 3/8″ square ratchet. Turn it clockwise to loosen.
To completely flush the transmission fluid, perform Step 2 through Step 4 three times. Figure 2. Transmission drain plug on 2000 Honda Accord. Figure 3. Drain plug removed. Replace drain plug. Open the hood and remove the transmission fluid dipstick. The handle will be yellow and located near the battery.
Open the hood and remove the transmission fluid dipstick. The handle will be yellow and located near the battery. Insert funnel and fill the transmission with three quarts of Honda ATF. Figure 4. Location of transmission fluid dipstick. Figure 5. Refilling transmission fluid dipstick.
How do you unclog an A / C unit in a Honda Accord?
Connect the drain tube hose to the vacuum. Disconnect the vacuum hose from the drain tube. Start your car, and let it run for a couple minutes. Finally, turn on your A/C to make sure that cold air is coming out. Figure 6. The unclogged evaporator may leak water.
How does the a / C system in a Honda Accord work?
Your A/C may not be in the best shape to perform. As air runs through a series of tubes and components of the A/C system, the evaporator removes hot air from inside the cabin to turn it into frigid, cool air. During that process, the evaporator also produces condensation, which is then dripped through a tube and released underneath the car.