Where is the radio fuse on a 2004 Yukon?

Where is the radio fuse on a 2004 Yukon?

The underhood fuse/relay center is located in the rear of the engine compartment near the brake fluid reservoir.

What to do if your Yukon Denali Radio is not working?

I have a 1999 yukon denali with RPO code Y91… I completely removed it cause I think they are crap. And installed after market amp HU and speakers including sub of course. But if the radio is not working.. make sure antenna is plugged in or if you have a powered antenna make sure that remote turn on wire is hooked up. Was this answer helpful?

Where is the radio amplifier on my GMC Yukon?

Other than the Tahoe Limited Edition, the vehicle was redesigned for the 2000 model year on the new GMT800 platform, still shared with the full-sized pickups and SUV’s. Location of radio amplifier? My amp keeps cutting out, shuting off the sound.

Why does my car radio stop working after I Turn Off the battery?

There are a few different reasons for a car radio to stop working after the battery has gone completely dead. The first, and by far most common, is that the radio has an anti-theft “feature” that kicks in whenever battery power is removed.

How to unlock GM radios 2000-2005-youtube?

If playback doesn’t begin shortly, try restarting your device. An error occurred. Please try again later. (Playback ID: a4bC2GufdZMMlXsG) Videos you watch may be added to the TV’s watch history and influence TV recommendations.

Why is my Chevy TheftLock radio not working?

The radio display will read “LOC” and the device will not turn on. Whenever your Chevy battery is disconnected or the battery dies, the Delco Theftlock radio enters the “LOC” mode. Follow these steps and you can reset the anti-theft radio and return the radio to a working state.

Why does my radio not work in my car?

For instance, if your radio turns on and displays a station, but no sound comes out of the speakers, then it’s probably an issue with the speakers or the wiring or even the antenna. In that same vein, a car stereo with a non-functioning radio may be tracked down to an antenna problem if other audio sources, like the CD player, work just fine.

How to reset an anti-theft radio on a Chevy?

Press the “AM/FM” button until “SEC” appears on the radio display. Press the “ON” button on the radio. The radio is now reset. Press the “Minute” and “Hour” buttons slowly until the security code matches. Going too fast may cause you to skip over the correct numbers of the security code. Store your radio security code in a safe place.

What to do when your car stereo stops working?

First, your battery went dead, and now your car stereo is dead, and it’s really shaping up to be just one of those days. So you drive the rest of the way to work in silence, and you hope that the next step isn’t going to be buying a brand new car stereo. And it probably isn’t.