What is the thermostat number on a 1997 Honda Civic DX?
Today’s test vehicle is a 1997 Honda Civic DX and we’ll be replacing the thermostat part number 19301-PAA-306. This vehicle is equipped with the SOHC D16 engine, a 1.6 liter non-VTEC engine. Once you have the coolant drained from your engine, you can begin our how to guide on how to replace a Honda Civic thermostat.
Where is the drain bolt on a Honda Civic?
Figure 2. Engine block drain bolt location. Locate the thermostat housing. You can do so by following the upper radiator hose to the engine block. Position your drain pan as best you can under the hose, so that it can catch any fluid when you disconnect it.
How do you flush the radiator in a Honda Civic?
However, many people do partial flushes (removes about 3/4th’s of the fluid) due to the huge hassle it is to get to this bolt, and to re-torque it. The bolt is located on the engine block close to the oil filter. Place your drain pan as best you can underneath. Loosen the bolt until fluid begins to flow out.
Where is the oil filter on a Honda Civic?
If you want to do a full flush, this step is necessary. However, many people do partial flushes (removes about 3/4th’s of the fluid) due to the huge hassle it is to get to this bolt, and to re-torque it. The bolt is located on the engine block close to the oil filter.
How do you replace the thermostat on a Honda Civic?
Loosen the hose clamp from the thermostat housing with a screwdriver and remove the hose. Remove the three bolts securing the housing with a wrench. Remove and discard the thermostat. Clean the housing of any gasket remnants with a putty knife. Insert the new thermostat into the housing.
What should I do if my Honda Civic overheats?
When you have confirmed that the radiator has sufficient coolant, the indication is that the thermostat is failing or has failed. A stuck thermostat causes overheating which can damage the engine, sometimes beyond repair. Buy a new thermostat at an auto parts store and replace it at home in minutes. Raise the hood of your Civic.
Figure 2. Engine block drain bolt location. Locate the thermostat housing. You can do so by following the upper radiator hose to the engine block. Position your drain pan as best you can under the hose, so that it can catch any fluid when you disconnect it.
How do you replace the radiator cap on a Honda Civic?
Once the air bubbles are out of the system, replace the radiator cap. Make sure the reservoir is still full, and then allow the car to run until warm. Allow the car to run for 3 to 5 minutes while warm. Turn off the car, and allow it to cool down.
Today’s test vehicle is a 1997 Honda Civic DX and we’ll be replacing the thermostat part number 19301-PAA-306. This vehicle is equipped with the SOHC D16 engine, a 1.6 liter non-VTEC engine. Once you have the coolant drained from your engine, you can begin our how to guide on how to replace a Honda Civic thermostat.
Can a stuck thermostat cause a Honda Civic to overheat?
A stuck thermostat causes overheating which can damage the engine, sometimes beyond repair. Buy a new thermostat at an auto parts store and replace it at home in minutes. Raise the hood of your Civic. Pull the cover off the radiator. Place a drain pan beneath the radiator drain plug on the driver side of the car.
When to flush the radiator in Honda Civic?
Overtime, the coolant breaks down and picks up contaminants from your cooling system, so flushing around the 50 to 100k interval can help prolong the life of your motor. By performing a flush versus a drain, you are removing all the old coolant as well as any contaminants that may have settled in the system.