Where is the dipstick on a 1999 Isuzu Rodeo?

Where is the dipstick on a 1999 Isuzu Rodeo?

There is no dipstick tube on this vehicle. The fluid is checked using the following procedure: Remove the transmission overfill screw (1) and fill transmission through overfill screw opening, using DEXRON III ATF . NOTE: Add transmission fluid until it flows out over the overfill screw opening.

How do I add transmission fluid to my Isuzu Rodeo?

Add the transmission fluid by sticking a long plastic tube inside the recessed hole and using a transmission fluid pump on the other end of the plastic hose. Fill the transmission with the engine running until fluid runs out the recessed fill hole. Remove the plastic hose. Reinsert and tighten the fill plug.

What kind of transmission fluid does a 1998 Isuzu Rodeo take?

Valvoline Synthetic Transmission Fluid Dexron VI 1 Quart.

When to change transmission fluid in an Isuzu Rodeo?

Isuzu recommends you change the fluid in your Rodeo’s transmission after 50,000 to 75,000 miles of wear. Whether it’s time for a transmission fluid change or not, you need to periodically check your Rodeo’s transmission fluid level and add fluid if necessary.

Where is the transmission dipstick on an Isuzu Rodeo?

Remove the plastic hose. Reinsert and tighten the fill plug. If the Isuzu Rodeo has an automatic transmission, you will check the transmission fluid level with the dipstick. If adding fluid is necessary, you’ll add fluid through the filler neck where the dipstick seats. Locate the transmission dipstick on the passenger side of the engine bay.

Where is the drain plug on an Isuzu Rodeo?

The drain plug is in the middle of the transmission on the bottom. The fill plug is about 6 inches to the rear of the drain plug; it will be inside a recessed groove on the rear of the oil pan.

How to check the fluid level in the transmission?

2. Open the Hood – How to pop the hood and prop it open 3. Remove Dipstick – Access point for transmission fluid 4. Check Level – Insert dipstick and pull it out to determine level 5. Add Fluid – Determine correct fluid type and add fluid 6. Replace Dipstick – Put the dipstick / cap back in place 7. More Info.