Why is my serpentine belt not fitting?

Why is my serpentine belt not fitting?

Serpentine belt problems usually result from one of three causes: a defective belt tensioner; misalignment of a pulley; or, defective bearings in the tensioner, idler, or one of accessories driven by the belt (including the water pump). Excessive cracking: Other than severe old age, defective tensioner.

Where is serpentine belt located?

The exact location of the serpentine belt may vary depending on the car. For most cars, the belt will be located at the front of the engine. When checking the belt, always make sure the car is switched off and cooled down. Your belt should be inspected with each oil change.

How can I tell when to replace my serpentine belt?

Your mechanic can let you know when to replace the serpentine belt or how many miles it has left. Look on the inside of the belt (the ribbed side that touches the pulleys on the alternator, water pumps, and other engine accessories).

Where do I find the serpentine belt routing diagram?

Find the serpentine belt routing diagram. Many cars come with a sticker in the engine bay that shows exactly how the serpentine belt is supposed to be routed through the various pulleys on the engine. If your vehicle does not have a sticker, you will need to find another way to remember how the belt should be run.

Can a car run without a serpentine belt?

However, these devices cannot function properly without the help of a serpentine belt. This one long continuous belt is the force that drives many of the engine’s peripheral devices. There is usually a belt tensioner or idler pulley to guide the belt as it moves. What is a Serpentine Belt? What is a Serpentine Belt?

How is the tension set on a serpentine belt?

Depending on the application, your serpentine belt will either have tension placed on it using a movable bracket or an auto tensioner pulley. This pulley uses an internal spring to apply consistent pressure to the belt at all times. If your vehicle does not have a tensioner pulley, the alternator bracket is likely how tension is set on the belt.