How do you reset the steering wheel on a clock spring?
How to reset a clock spring?
- Start the engine and let it idle.
- Turn the steering wheel all the way to the right.
- Turn the steering wheel all the way to the left.
- Repeat this procedure twice with the engine running.
- Drive for at least 50 feet, and the steering angle sensor will reset.
Is it safe to replace clock spring?
Can You Re-use a Clock Spring? After a repair, there is no problem reusing a clock spring if you removed the clock spring correctly. In most car models, you need to make sure the steering wheel is in the middle when you remove it. You should also mark the position on the steering axle compared to the steering wheel.
Can a clock spring be removed from a steering wheel?
A general rule of thumb is if the steering wheel has a bolt it will lift off, and if it is using a nut it will need a puller. 4. Remove the Clock Spring: The clock spring sits over the center shaft of the steering column and is held in place by a set of small screws or plastic clips.
How do you remove clock from steering column?
Using a small pick or screwdriver to release the plastic retainer clips while pulling the unit outward. This is required on some models. Gently work the clock spring back and forth and outward from the steering column shaft and gently remove.
How to remove clock spring from Ford PowerStroke?
Remove steering wheel by pulling outwards (no puller required). remove the clock spring by removing the two T-20 torx head screws. step 11 install new clock spring and re-install steering wheel, its now okay to pull out and remove the yellow alignment ripcord.
Where is the clock spring on a car?
The clock spring is usually located on the steering column behind the steering wheel. Almost every road going vehicle with a steering wheel has one of these devices. However, if your vehicle has no airbag, steering wheel controls, or horn buttons, you may not have a clock spring.