How to replace clutch on Honda Civic Si?
Get a box of exam gloves and change them often. Also, get some steel wool or scotchbrite pads, some penetrating oil, a steel brush, and several cans of brake parts cleaner. – Thick blanket. Like a furniture blanket. You’ll have the transmission in your lap and this will save your legs.
How do you replace the flywheel on a Honda Civic?
Use the following steps to replace the flywheel and clutch on your Honda Civic. The quickest way to reach the clutch is from underneath the chassis. In order to do this, use a jack to raise the vehicle and a pair of jack stands to support the chassis in the air. Also use this as an opportunity to drain the transmission fluid. Figure 1.
Where are the transmission bolts on a Honda Civic?
Remove the transmission top mount’s 17mm bolts. Proceed to remove the front transmission mount (three 17mm bolts and two 14mm bolts). Remove the final 19mm mount bolt located behind the transmission. Once done, loosen all four bolts that connect the transmission housing to the engine.
What should I do before replacing my Clutch?
There will be several subsequent guides that will need to be performed before the clutch can be replaced which are listed below: 1. Remove the Clutch: Once the above jobs have been done it’s time to inspect and remove the clutch pressure plate.
What kind of clutch does a Honda Civic have?
This article breaks down a complicated process and takes you step-by-step in how to correctly replace the flywheel and clutch on your Honda Civic. This article applies to the Honda Civic (1992-2000). Your Honda Civic uses a hydraulic clutch system to engage the transmission into the gears.
How long does it take to replace clutch on civic?
I can do this particular car in around 3-4 hours if I don’t get distracted. Realistically, you should give yourself 8-10 hours of actual work time plus whatever you spend fixing as you go. There are probably several different ways to approach this kind of work depending on the equipment available to you.
Use the following steps to replace the flywheel and clutch on your Honda Civic. The quickest way to reach the clutch is from underneath the chassis. In order to do this, use a jack to raise the vehicle and a pair of jack stands to support the chassis in the air. Also use this as an opportunity to drain the transmission fluid. Figure 1.
Remove the transmission top mount’s 17mm bolts. Proceed to remove the front transmission mount (three 17mm bolts and two 14mm bolts). Remove the final 19mm mount bolt located behind the transmission. Once done, loosen all four bolts that connect the transmission housing to the engine.
Get a box of exam gloves and change them often. Also, get some steel wool or scotchbrite pads, some penetrating oil, a steel brush, and several cans of brake parts cleaner. – Thick blanket. Like a furniture blanket. You’ll have the transmission in your lap and this will save your legs.
Do you need wheel chocks for Honda Civic?
Wheel chocks are not optional. If the car rolls and falls off of the jackstands onto you, you will die. Use a hydraulic jack rated for at least twice the full weight of the car. (1.5 tons X 2) – Cardboard to work on. Get several sheets.
How big should the flywheel be on a Honda Civic?
You can try to have the flywheel resurfaced but getting it done correctly is a crapshoot. If you have a local shop that does flywheel resurfacing, you’re better off to try to sell them your old flywheel and then buy a brand new one. The flywheel should weigh at least 15 lbs or it will cause a check engine light.
What is the clutch interlock switch on a Honda Civic?
The Honda Civic, as with most modern cars, uses a clutch interlock switch that is similar to the neutral-safety switch on cars with automatic transmissions. Where a neutral-safety switch prevents the engine from starting unless the shifter is in Park or Neutral, the clutch interlock prevents the engine from starting unless the clutch is pushed in.
How to troubleshoot a Honda Civic clutch starter switch?
Push in on the clutch pedal while your assistant turns the key to the “Start” position. Test the wires again. If only one wire illuminates the test light, the switch is bad.
Push in on the clutch pedal while your assistant turns the key to the “Start” position. Test the wires again. If only one wire illuminates the test light, the switch is bad.
Where is the interlock switch on a Honda Civic?
Slide the driver’s seat all the way back because you are going to have to lay on the floorboard so you can reach the interlock switch which is mounted on the top of the clutch pedal. Move under the dash and find the interlock switch mounted on the top of the clutch pedal. It has two wires running to it.