Is there a way to bleed the rear brakes?
Stop the vehicle afterward and bleed the rear brakes. Attach a pressure bleeder to the master cylinder reservoir and turn the ignition key to the On position. Pressurize the system to 35 pounds per square inch with the bleeder screws closed. Connect the scan tool and set it to “Automatic Bleed Procedure.”
How to bleed ABS brakes without scan tools?
The Procedure of How to Bleed ABS Brakes. 1 Loosen the Bleeder Valves. After preparing the vehicle, your first task is to loosen the bolts of the bleeder valves. Use a box wrench for the job. If 2 Remove the Old Fluid. 3 Bleed the ABS System. 4 Bleeding with a Scan Tool.
What happens when you bleed the brake pedal?
Bleed the brake on the opposite end next (the left front if you started with the right front). Test the brake pedal after all the brakes are bled. Once you are certain of a firm pedal, drive the vehicle at more than three miles per hour so the controller can automatically reset the system.
How to bleed the ABS on a C / K 1500?
Wait one minute for the tool to energize and cycle the ABS solenoids. Bleed each wheel as the scan tool instructs you to. The pump will run and the release valve on each wheel will cycle for one minute. Afterward, the scan tool purges any extra air with one last 20 second cycling of the solenoids.
Stop the vehicle afterward and bleed the rear brakes. Attach a pressure bleeder to the master cylinder reservoir and turn the ignition key to the On position. Pressurize the system to 35 pounds per square inch with the bleeder screws closed. Connect the scan tool and set it to “Automatic Bleed Procedure.”
Bleed the brake on the opposite end next (the left front if you started with the right front). Test the brake pedal after all the brakes are bled. Once you are certain of a firm pedal, drive the vehicle at more than three miles per hour so the controller can automatically reset the system.
Where is The Bleeder on a GM car?
The GM vehicles using the DBC-7 system include many recent Chevy and Pontiac cars, so check with your manual or dealer to see which braking system your GM vehicle has. Open the front bleeder screw on the modulator. There are two screws, open the one at the front.