Does Honda Civic 2008 have Immobiliser?
To reset the immobilizer on a 2008 Honda Civic Put the key into the ignition and rotate it 2 clicks to the accessory mode. The drivers display will illuminate, with the key still in ignition go down to the kick panel area and find the little black button next to the hood release lever.
How does the immobilizer system work on a Honda?
Turn the ignition switch to the LOCK (0) position, remove the key, reinsert it, and turn the ignition switch to the ON (II) position again. The Immobilizer System protects your vehicle from theft. If an improperly-coded key (or other device) is used, the engine’s fuel system is disabled.
How do you add a key to a Honda immobilizer?
Use the Honda Diagnostic System ( i-HDS) with Honda key blanks to add a key. The i-HDS rewrites the immobilizer control unit-receiver, storing the transponder code of the new key in the memory of the immobilizer control unit-receiver.
What does serial code mean on Honda immobilizer?
If the codes match, the immobilizer control unit-receiver sends a unique serial code to the ECM/PCM. But if the transponder ID code does not match, no serial code is sent, and the vehicle won’t start.
What is the bypass sequence for Honda Civic EX?
I have a 2002 Honda Civic ex and lost the transponder key. What is the immobilized bypass sequence for my vehicle??! Please help, I live rural and … read more
How does the Immobilizer work on a Honda?
Each master key and valet key has electronic circuits in its grip that output a rolling-type code (set by the immobilizer control unit-receiver) when you insert the key into the ignition switch. The immobilizer system uses this code to determine whether to start the engine.
If the codes match, the immobilizer control unit-receiver sends a unique serial code to the ECM/PCM. But if the transponder ID code does not match, no serial code is sent, and the vehicle won’t start.
What to do if your Honda i-HDS immobilizer is not logged in?
If your i-HDS is not logged in to the iN, you will have to enter the PCM code you have retrieved from the iN Immobilizer Code Inquiry to proceed. When you are finished, turn the ignition switch to LOCK (0), then turn off and disconnect the i-HDS. NOTE: Refer to the parts catalog for the P/Ns, and search by VIN for the correct parts.
When does the immobilizer system indicator go out?
When you turn the ignition switch to the ON (II) position, the immobilizer system indicator should come on for a few seconds, then go out. If the indicator starts to blink, it means the system does not recognize the coding of the key.