Which is the best oil additive for a noisy engine?

Which is the best oil additive for a noisy engine?

If you currently have a noisy engine, that should get reduced too. The Lucas Heavy Duty Oil Stabilizer is an oil additive that will last you for at least 2 years. It will prolong the lifespan of your existing oil, so you won’t need to get oil changes as frequently.

Is it OK to warm up your engine before driving?

Idling or pre-heating as you may call it also emits harmful emissions into the environment. Car manufacturers have thus enabled a system where the glow plug would light up only when the engine starts. The glow plug is also liable to switch on when the engine temperature has decreased exponentially.

What does the chirping cam on a Vortec 5300 mean?

Just thinking the blockage blew through and sticking lifter . And the chirping cam must be next in the oil passage routing for the debris if any and chirping might be cam bearings being drier causing a metal on metal squeal. What do you think?

Why does my Silverado Sierra have vibration issues?

Either the tire/wheel assemblies have excessive radial force variation, the rear driveshaft (propshaft) is out of balance or the right side engine mount needs to be shimmed 3 mm. Those are the only vibration issues that I have seen with a K2XX truck. For the money they are asking for these vehicles, they should not have issues like this.

Why does my Silverado shake when going up hill?

It seems to be most noticeable going up or down hill with very light acceleration but can do it on level ground at cruise speed too. And the fun part is it doesn’t always do it to make it more of a challenge to diagnose it.

How can I get rid of the lifter noise?

Allow the engine to idle for 20 minutes, repeating the lifter pump-up procedure in step three about once every three minutes. Drain the oil, unscrew the old filter from the block, replace it with a new one and re-fill the engine with the recommended oil.

What kind of engine noise does a 94 Silverado make?

I wanted to add my recent experience to this thread…I recently purchased a 94 Silverado with the 4.3L balance shaft design. 139k miles and 180psi on all cylinders. Loud rattling noise just over 1K rpms.