How do you remove a swing arm shaft on a Harley Davidson?
MAKE SURE YOU SUPPORT THE BACK OF THE TRANNY BEFORE YOU REMOVE THE SWING ARM SHAFT. SCISSOR-JACK WITH A 2×4 ON TOP IS PRETTY GOOD. Well there is your answer. Tap it out from the left side towards the right. Left side nut is off!
What’s the best way to remove a swingarm?
I than strap the dolly and the front end along with the rear of the bike to the (Handy) table. This helps greatly when using the Saws-All to remove the stubborn swingarm (should be your last option). • Remove your rear wheel & set aside, make sure you use a brass drift pin for axle removal.
Can a pivot shaft be removed from a swing arm?
Following the Service manual I tried to remove the swing arm pivot shaft. Got all the way down to “tapping” the shaft out from the right side and it would not budge no matter how hard I hit it.
When did Harley Davidson upgrade their swingarms?
In 2002 Harley upgraded the swingarm by making a new swingarm that is more ridged and stronger. Here are some of the differences: 1. The swingarm had been strengthened in the areas shown above in 2002. The 2007 has undergone another change not covered here.
MAKE SURE YOU SUPPORT THE BACK OF THE TRANNY BEFORE YOU REMOVE THE SWING ARM SHAFT. SCISSOR-JACK WITH A 2×4 ON TOP IS PRETTY GOOD. Well there is your answer. Tap it out from the left side towards the right. Left side nut is off!
How do you change the swingarm on a rogue?
Here’s a shot of good Dr. Rogue working his magic with the shop press. Remove the rear wheel, swingarm end-caps and pivot shaft. Once the swingarm is removed use a hydraulic press to remove the old Clevebloc assemblies, clean all parts. The kit comes with Red Locktite (626) and Antisieze.
I than strap the dolly and the front end along with the rear of the bike to the (Handy) table. This helps greatly when using the Saws-All to remove the stubborn swingarm (should be your last option). • Remove your rear wheel & set aside, make sure you use a brass drift pin for axle removal.
In 2002 Harley upgraded the swingarm by making a new swingarm that is more ridged and stronger. Here are some of the differences: 1. The swingarm had been strengthened in the areas shown above in 2002. The 2007 has undergone another change not covered here.
Where is the nut on a Harley Davidson swingarm?
The nut on the right side is made on the axle. tap the left side of axle with a brass hammer while turning the right side nut counter clock wise and axle should come out. Sorry Art was thinking about axle. The swing arm bolt can be a real pain if it didn’t have anti-seiser (miss spelled) on it when installed.
Can a swing arm bolt be a pain?
The swing arm bolt can be a real pain if it didn’t have anti-seiser (miss spelled) on it when installed. Try turning the nut on the right counterclock wise while tapping on the left side. Hi all, trying to put a new belt on my 02 Roadking and I’m down to the swingarm shaft.
How do you close the modal on a Harley Davidson?
This modal can be closed by pressing the Escape key or activating the close button. This is a modal window. This modal can be closed by pressing the Escape key or activating the close button. This is a modal window. Sign up for premium membership and get access to our best Harley repair videos and step-by-step instructional projects.