How do you turn the airbag off in a Volvo v50?

How do you turn the airbag off in a Volvo v50?

The passenger airbag can be deactivated if the car is equipped with a switch, Passenger Airbag Cut Off Switch (PACOS). The switch for the passenger airbag is located on the passenger end of the instrument panel and is accessible when the passenger door is open. Check that the switch is in the required position.

How do you turn the airbag off?

But the passenger airbag can be deactivated if the car is equipped with a Passenger Airbag Cut Off Switch (PACOS). In most cases, to disable the airbag you need to have the ignition switched off to avoid any possible malfunctions. The PACOS is usually located in the passenger side of the dash board.

Can You unplug the SRS airbag control module?

You are now safe to unplug the airbag control module harness wiring plugs. All airbag srs components must be installed and connected properly before installing the airbag control module. This includes air bags, seat belts, clock spring and impact sensors. Disconnect the battery and bolt down the module and then connect the harness wiring plugs.

How do you install an airbag control module?

All airbag srs components must be installed and connected properly before installing the airbag control module. This includes air bags, seat belts, clock spring and impact sensors. Disconnect the battery and bolt down the module and then connect the harness wiring plugs.

What to do if your front airbag resistance is too high?

Never disassemble or tamper with safety belt buckle/retractor pretensioners, adaptive load limiting retractors, safety belt inflators, or probe the electrical connectors. Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.

How long does it take for Nissan assist air bag to deploy?

Do not use electrical test equipment to check SRS circuits unless instructed to in this Service Manual. Before servicing the SRS, turn ignition switch OFF, disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pre-tensioner to deploy.