How to replace tailgate brake light on VW California?

How to replace tailgate brake light on VW California?

I used trim removal tools, a long screwdriver with the end covered in masking tape and a couple of bike tyre levers. When doing this job, you dont need to remove the trim completely. Just pull the upper horizontal part off and you have then access to the three screws holding the light.

Where is the brake light switch on a car?

To get to the switch, take a look right above brake pedal. The switch is typically a small plastic box with 2 or 3 wires coming from it. It will make contact with the brake lever towards the top. Note: You may have to remove a plastic panel before you can access this area.

How to reset the ABS warning light on a VW Caddy Mk3?

To be exactly sure where the fault is, you should use the iCarsoft i908 VW OBD Code Reader kit. Once the fault is repaired you can use the iCarsoft i908 VW OBD Code Reader to reset the trouble codes and reset the ABS warning light in your VW Caddy Mk3.

What kind of brake light does a caddy have?

Brand new, genuine Volkswagen Caddy 2004-2016 rear high level brake light for barn doors or tailgate models. Item is BRAND NEW and GENUINE! Please see our other items for 100s of other parts!

How to change the light bulb on a VW Caddy?

(Playback ID: wHEBJ3zZTBiNOB12) An error occurred while retrieving sharing information. Please try again later.

When to put brake pads off a VW?

These sensors may be on one side of the vehicle or both. If you see the VW brake warning light illuminated on your dash board instrument cluster, brake repair service is imminent. You have roughly 1,000 – 3,000 miles left on your front pads and VW brake rotors. It’s smart not to put brake service off.

Where is the brake warning light on a VW?

These sensors may be on one side of the vehicle or both. If you see the VW brake warning light illuminated on your dash board instrument cluster, brake repair service is imminent.

When to replace the brake hub on a VW?

VW wheel hub [Above IMAGE 1]. If the rusting and pitting is horrible the hub should be replaced. If it isn’t replaced, the new VW brake rotors won’t ride 100% true. Use a brake hub and rotor True Gauge Tool to confirm correct VW brake rotor alignment.