Where is the SRS fuse on a 2000 Honda Accord?
-The SRS connector is plugged into the upper right corner of the driver’s side under dash fuse panel or behind the driver’s side left kick panel.
How to reset the SRS light on a Honda Accord?
(1) Locate MES Plug. It should be located near the driver’s side fuse panel under the dash. The harness is yellow with two wires. (2) Unplug the MES Plug. -Short and hold the leads while you turn the ignition to on. The SRS Light will illuminate for a few seconds then go off. -When the SRS Light goes off, unshort the wires.
How do you turn off the SRS light?
MES connector with “short” wire. With this connection made, turn the ignition key to the “on” position (do not start the engine). The SRS will illuminate for two seconds, then turn off. When the light turns off, disconnect the shorting wire to un-short the circuit. The SRS light will turn on again. When it does, reconnect the shorting wire.
Where is the SRS plug on a Honda Accord?
(1) Locate MES Plug. It should be located near the driver’s side fuse panel under the dash. The harness is yellow with two wires. (2) Unplug the MES Plug. -Short and hold the leads while you turn the ignition to on. The SRS Light will illuminate for a few seconds then go off.
Why does my Honda SRS light keep blinking?
The SRS light will blink twice indicating the SRS system and the light are reset. If this procedure is followed correctly and the light remains on, then there may be an actual issue with the SRS system. In this case, it is advised to bring the vehicle to the dealership, where the trouble code can be identified and the issue repaired.
(1) Locate MES Plug. It should be located near the driver’s side fuse panel under the dash. The harness is yellow with two wires. (2) Unplug the MES Plug. -Short and hold the leads while you turn the ignition to on. The SRS Light will illuminate for a few seconds then go off. -When the SRS Light goes off, unshort the wires.
MES connector with “short” wire. With this connection made, turn the ignition key to the “on” position (do not start the engine). The SRS will illuminate for two seconds, then turn off. When the light turns off, disconnect the shorting wire to un-short the circuit. The SRS light will turn on again. When it does, reconnect the shorting wire.
How to reset or erase SRS airbag light?
How To Reset or Erase SRS Airbag Light on Honda and Acura. – YouTube If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations.
(1) Locate MES Plug. It should be located near the driver’s side fuse panel under the dash. The harness is yellow with two wires. (2) Unplug the MES Plug. -Short and hold the leads while you turn the ignition to on. The SRS Light will illuminate for a few seconds then go off.