Why does my Silverado Sierra make a squeaking sound?

Why does my Silverado Sierra make a squeaking sound?

I took my main belt off and started the motor to see if the squeak was coming from the cam shaft in the engine it self, where was no squeak so that ruled that out for me. You can remove the belt and start the engine for a quick test but not to long. I’m having this problem also. This has been ongoing for the last 7 weeks.

Are there any problems with the GMC Sierra 1500?

302-horsepower 4.8L V8 4-speed automatic 4WD w/low range service traction control light was coming on. The vehicle wouldn’t go over 35 mph. Battery disconnect reset the problem temporarily It was actually a problem with the throttle body. Found out later it was a recall. Replaced coil and plug wire for Cylinder 6.

What causes vibration in a GMC Sierra 1500?

Vibration when in V4 mode some clamps were replaced on the exhaust system, the vibration is still there between 1200-1400 rpm. engine vibration in V4 mode, exhaust system replaced, defective valve in exhaust found.

What’s the noise in my 4 wheel drive truck?

The truck has had a weird vibration in the steering wheelthat I have been noticing along with the noise when turning in 4 wheel drive on not totally snow covered roads. This vibration in the steering wheel is not a shimmy but a vibration at any speed felt on the steering wheel.

I took my main belt off and started the motor to see if the squeak was coming from the cam shaft in the engine it self, where was no squeak so that ruled that out for me. You can remove the belt and start the engine for a quick test but not to long. I’m having this problem also. This has been ongoing for the last 7 weeks.

When did the GMC Sierra have the most problems?

The model years with the most problems reported were 2004 and 2007, with more than 60 complaints each year, followed by 2002, 2003, 2005, and 2010, with more than 40 each year. Of the 112 problems, five different complaints have been reported 90 or more times.

Why is my Silverado stuck in 4WD Low?

“Service 4wd” started coming back on, and this morning I couldn’t get it out of 4wd low. Any ideas on what could be causing it, and how can i get it out of 4wd low? If its not the switch then it’s the actuator Both are fairly simple to fix. where is the actuator? and what about the encoder motor sensor? I am having a very similar problem.

What kind of truck is a 2005 GM Sierra?

From buying research to owner support, join 1.5 MILLION GM Truck Enthusiasts every month who use GM-Trucks.com as a daily part of their ownership experience. I drive a 2005 Sierra with the push button 4wd. About a year ago, my “service 4wd” message would come on sporadically.